COMBINED SENSOR INITIALIZATION PROCEDURE

id041500801400

Warning

•  If the initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing or removing the combined sensor or DSC HU/CM, make sure to perform the initialization procedure to insure proper DSC operation.

1.  Inspect the wheel alignment and the tire pressure.

•  If there is any malfunction, adjust the applicable part.

2.  Position the vehicle on level ground.

3.  Turn the ignition switch off.

4.  Connect the M-MDS to the DLC-2.

am3zzw00001646

5.  After the vehicle is identified, select the following items from the initial screen of the M-MDS.

•  When using the IDS (laptop PC)

1.  Select “Chassis“.

2.  Select “ABS/DSC“.

3.  Select “Sensor Initialization“

•  When using the PDS (Pocket PC)

1.  Select “Module Tests”.

2.  Select “ABS”.

3.  Select “DataLogger”.

4.  Select “LATACCEL”.

6.  Perform the initialization procedure according to the directions on the screen.

7.  Drive the vehicle.

8.  After 5 min or more of driving, verify that the DSC system is normal.