AUTO LIGHT ILLUMINATION LEVEL SETTING

id091800803300

1.  Connect the M-MDS to the DLC-2 connector.

am3zzw00001092

2.  After the vehicle is identified, select the following items from the initial screen of the M-MDS.

•  When using the IDS (laptop PC)

1.  Select “Module Programming”.

•  When using the PDS (Pocket PC)

1.  Select “Programming”.

2.  Select “Module Programming”.

3.  Then, select items from the screen menu in the following order.

1.  Select “Programmable Parameters”.

2.  Select “Exterior Lighting”.

3.  Select “Autolamp On Setting-(GEM)”.

4.  Select “Low” or “Standard” on the M-MDS to set the illumination level.

Note

•  When the M-MDS is set to Low, the auto-light sensor sensitivity decreases, and the TNS and headlight illumination timing is slower.