PRIMARY SHAFT COMPONENT PREINSPECTION
id051500175600
5th Gear Thrust Clearance Inspection
1. Measure the 5th gear thrust clearance using the following procedure:
- (1) Secure the primary shaft component using a vice.
-
-
Caution
-
• Insert a protective plate between the vise and the part so as not to damage the part.
- (2) Set the dial gauge to the position of the arrow shown in the figure.
- (3) Move the 5th gear in the axial direction and measure the 5th gear thrust clearance.
-
-
• If it exceeds the maximum specification, inspect the 5th gear and surrounding parts for damage and wear and replace the malfunctioning part.
-
5th gear thrust clearance
-
Specification: 0.227 mm {0.00894 in}
Maximum: 0.303 mm {0.0119 in}
6th Gear Thrust Clearance Inspection
1. Measure the 6th gear thrust clearance using the following procedure:
- (1) Secure the primary shaft component using a vice.
-
-
Caution
-
• Insert a protective plate between the vise and the part so as not to damage the part.
- (2) Set the dial gauge to the position of the arrow shown in the figure.
- (3) Move the 6th gear in the axial direction and measure the 6th gear thrust clearance.
-
-
• If it exceeds the maximum specification, inspect the 6th gear and surrounding parts for damage and wear and replace the malfunctioning part.
-
6th gear thrust clearance
-
Specification: 0.208 mm {0.00819 in}
Maximum: 0.299 mm {0.0118 in}