Mazda3 BRAKE DISC INSPECTION
id942000401400
-
Warning
-
• Do not use the vehicle-equipped jack to jack up the vehicle for brake disc inspection. The jack may slip during servicing and cause an accident. Always use a lift or a garage jack to jack up the vehicle and use a rigid rack when performing brake disc inspection.
Required tools
• Micrometer
• Torque wrench
• Handle
• Socket (21 mm)
Front Brake Disc Inspection
1. Remove the front tire.
2. Clean the brake disc surface where it contacts the pad using brake cleaner.
3. Measure the thickness of the brake disc using a micrometer.
-
• If the brake disc thickness is the usable minimum or less, the brake disc has to be replaced with a new one. Consult a Mazda Dealer for replacement.
-
Brake disc usable minimum thickness
-
23.0 mm {0.906 in}
-
Standard brake disc thickness (New part)
-
25.0 mm {0.984 in}
4. Install the front tire and tighten the nuts to the specified torque.
-
Tightening torque
-
108—147 N·m {12—14 Kgf·m, 80—108 ft·lbf}
5. After installation, pump the brake pedal a few times and verify that the brakes do not drag.
Rear brake disc inspection
Without electric parking brake
1. Remove the rear tire.
2. Clean the brake disc surface where it contacts the pad using brake cleaner.
3. Measure the thickness of the brake disc using a micrometer.
-
• If the brake disc thickness is the usable minimum or less, the brake disc has to be replaced with a new one. Consult a Mazda Dealer for replacement.
-
Brake disc usable minimum thickness
-
7.0 mm {0.28 in}
-
Standard brake disc thickness (New part)
-
9.0 mm {0.35 in}
4. Install the rear tire and tighten the nuts to the specified torque.
-
Tightening torque
-
108—147 N·m {12—14 Kgf·m, 80—108 ft·lbf}
5. After installation, pump the brake pedal a few times and inspect the following:
-
• Parking brake lever stroke
• Brake drag
With electric parking brake
1. Remove the rear tire.
2. Clean the brake disc surface where it contacts the pad using brake cleaner.
3. Measure the thickness of the brake disc using a micrometer.
-
• If the brake disc thickness is the usable minimum or less, the brake disc has to be replaced with a new one. Consult a Mazda Dealer for replacement.
-
Brake disc usable minimum thickness
-
7.0 mm {0.28 in}
-
Standard brake disc thickness (New part)
-
9.0 mm {0.35 in}
4. Install the rear tire and tighten the nuts to the specified torque.
-
Tightening torque
-
108—147 N·m {12—14 Kgf·m, 80—108 ft·lbf}
5. After installation, pump the brake pedal a few times and verify that the brakes do not drag.
