CYLINDER HEAD INSPECTION [MZR-CD 2.2]

id0110f2507100

1. Perform color contrast penetrate examination on the cylinder head surface.

• If there is a malfunction, replace the cylinder head.

2. Inspect for the following and repair or replace if necessary.

(1) Sunken valve seats

(2) Excessive camshaft oil clearance and end play

3. Measure the cylinder head for distortion in the seven directions as shown in the figure.

• If the distortion exceeds the maximum, replace the cylinder head. Do not attempt to repair the cylinder head by milling or grinding.

bem5ze00000064

Maximum distortion, head gasket side

X distortion: 0.01 mm {0.0004 in}

Y distortion: 0.04 mm {0.0016 in}

4. Measure the manifold contact surface distortion as shown in the figure.

• If the distortion exceeds the maximum, grind the surface or replace the cylinder head.

bem5ze00000065

Maximum distortion, manifold side

0.06 mm {0.0024 in}

Maximum grinding, manifold side

0.20 mm {0.008 in}