CRANKSHAFT, MAIN BEARING [SKYACTIV-G 2.0]
id0110h2000600
Purpose, Function
• The crankshaft converts the reciprocating movement of the piston to a rotational movement via the connecting rod.
• The main bearing forms an oil film on the outer surface of the crankshaft journal to prevent wear due to sliding.
Construction
Crankshaft
-
• The crankshaft is installed to the inside (crankcase) of the cylinder block.
• The crankshaft has a key groove to match timing to the crankshaft pulley.
• The crankshaft has the following parts shown in the figure.
-
• The optimized shaft diameter ratio of the crankshaft journal and crank pin has reduced sliding resistance while maintaining rigidity.
• The steel crankshaft has five bearings and eight counterweights for improved accuracy in the rotational balance.
• The crankshaft journal and crank pin have been induction hardened to bear high loads.
• The crankshaft has an oil passage for supplying engine oil to the crankshaft journal and crank pin.
Main bearing
-
• The main bearing is installed to the outer surface of the crankshaft journal.
• The upper main bearing and lower main bearing are made of aluminum alloy.
• The upper main bearing has an oil groove and oil hole.
• Thrust force is suppressed by the thrust bearings on both sides of the No.3 journal.
