ENGINE COOLANT PROTECTION INSPECTION [MZR 2.0 DISI i-stop]

id011237800400

1.  Measure the engine coolant temperature and specific gravity using a thermometer and a hydrometer.

Caution

•  Use engine coolant at a concentration that meets the environmental conditions in which the vehicle is driven, otherwise engine damage could occur.

•  The engine has aluminum parts and must be protected by an ethylene-glycol-based coolant to prevent corrosion and freezing.

•  Do not use coolants containing Alcohol, Methanol, Borate or Silicate. These coolants could damage the cooling system.

•  Use only soft (demineralized) water in the coolant mixture. Water that contains minerals will cut down on the coolant’s effectiveness.

•  Engine coolant damages paint. If engine coolant does get on a painted surface, rinse it off quickly.

Note

•  If the “FL22” mark is shown on or near the cooling system cap, use FL22 type engine coolant.

am2zzw00001691

•  FL22 type engine coolant is shipped as a diluted solution. Use the solution as is when replacing coolant.

2.  Determine the engine coolant protection level by referring to the graph shown in the figure.

am2zzw00001692

•  If the engine coolant protection level is not correct, add water or engine coolant.