STARTER INSPECTION [SKYACTIV-G 2.0]

id0119h7800300

On-vehicle Inspection

1.  Verify that the battery is fully charged.

2.  The starter is normal if it rotates smoothly and without any noise when the engine is cranked.

•  If the starter does not operate, inspect the following:

―  Remove the starter, and inspect the starter unit.

―  Inspect the related wiring harnesses, the ignition switch, and the transaxle range switch.

No-load Test

1.  Verify that the battery is fully charged.

2.  Connect the starter, battery, and a tester as shown in the figure.

am6xuw00002343

3.  Operate the starter and verify that it rotates smoothly.

•  If the starter does not rotate smoothly, inspect the starter unit.

4.  Measure the voltage and current while the starter is operating.

•  If not within specification, replace the starter.