MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR INSPECTION [MZR 1.5, MZR 1.6]

MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR INSPECTION [MZR 1.5, MZR 1.6]

id014068800900

Voltage Inspection

1. Connect the M-MDS to the DLC-2.

am3zzw00011557

2. Switch the ignition to ON.

3. Verify that the MAP sensor output voltage (PID: MAP) is within the specification. (See ON-BOARD DIAGNOSTIC TEST [MZR 1.5, MZR 1.6].) (See PCM INSPECTION [MZR 1.5, MZR 1.6].)

• If not as specified, replace the MAP sensor. (See MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)