CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTION [MZR-CD 2.2]

id0140f2801600

Caution

•  Inspect the CPP switch with it installed to the clutch pedal, otherwise the CPP switch may not operate normally after inspection. If the CPP switch is removed from the clutch pedal, replace the CPP switch with a new one.

Note

•  Perform the following test only when directed.

Continuity Inspection

1.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR-CD 2.2].)

2.  Disconnect the CPP switch connector. (See CLUTCH PEDAL REMOVAL/INSTALLATION.)

3.  Verify that the continuity between CPP switch terminals A and B when the clutch pedal is depressed and when it is released is according to the following table:

am3zzw00011600

•  If not as verified, replace the CPP switch. (See CLUTCH PEDAL REMOVAL/INSTALLATION.)