PCM CONFIGURATION [MZR-CD 2.2]


id0140f2802600

Caution
•  If the wheel and tire sizes are changed, a discrepancy with the speedometer needle whereby it exceeds the allowable range could result in a malfunction. If the wheel and tire sizes are changed, perform the following procedure to change the tire size parameter setting. (See PARAMETER SETTING PROCEDURE WHEN TIRE SIZE IS CHANGED.)

1.  Connect the M-MDS (IDS) to the DLC-2.

am3zzw00011609

2.  After the vehicle is identified, select the following items from the initial screen of the M-MDS (IDS).

(1)  “Module Programming”

3.  Select “Programmable Module Installation”.

4.  Select menu in the “PCM”.

5.  Perform the configuration according to the directions on the screen.

Note
•  If the PCM is replaced with a new one, the PCM stores DTCs P0602:00 and P1675:00, illuminates the MIL even though no malfunction is detected. When the configuration is completed, DTCs P0602:00 and P1675:00 are cleared.

6.  Retrieve DTCs by the M-MDS (IDS), then verify that there is no DTC present.

•  If a DTC(s) is detected, perform the applicable DTC inspection. (See DTC TABLE [MZR-CD 2.2].)