ACCELERATOR PEDAL POSITION (APP) SENSOR INSPECTION [MZR-CD 2.2]


id0140f2803200

Note
•  Perform the following inspection only when directed.

Sensor Output Value Inspection

Note
•  Because the APP sensor is integrated in the accelerator pedal component, replacing the APP sensor includes replacement of the accelerator pedal component.

1.  Connect the M-MDS to the DLC-2.

am3zzw00011610

2.  Switch the ignition to ON.

3.  Verify that the APP1 or APP2 PID (percentage) changes smoothly while accelerator pedal is gradually depressed. (See ON-BOARD DIAGNOSTIC TEST [MZR-CD 2.2].)

•  If verified, go to the next step.
•  If not as verified, replace the accelerator pedal component. (See ACCELERATOR PEDAL COMPONENT REMOVAL/INSTALLATION [MZR-CD 2.2].)

4.  Verify that the APP1 or APP2 PID is as indicated in the table below according to the condition of the accelerator pedal.

―  If not as specified, replace the accelerator pedal component. (See ACCELERATOR PEDAL COMPONENT REMOVAL/INSTALLATION [MZR-CD 2.2].)

Specification

Condition

APP1 PID (%)

APP1 PID (V)

APP2 PID (%)

APP2 PID (V)

Accelerator pedal is released.
0
Approx. 1.0
0
Approx. 1.6
Accelerator pedal is depressed.
100
Approx. 3.3
100
Approx. 3.9