REAR ABS WHEEL-SPEED SENSOR INSPECTION


id041300801200


Installation Visual Inspection

1.  Inspect for the following:

•  If there is any malfunction, replace the part.
(1)  Excessive looseness or play of the rear ABS wheel-speed sensor
(2)  Deformation of the rear ABS wheel-speed sensor
(3)  Deformation or damage of the rear ABS sensor rotor


Clearance Inspection

1.  Remove the rear ABS wheel-speed sensor.

2.  Measure the distance between the rear ABS wheel-speed sensor installation surface and the rear ABS sensor rotor. This is dimension A.

am3uuw00002548

3.  Calculate the clearance between the rear ABS wheel-speed sensor and the rear ABS sensor rotor using the following formula:

Clearance (mm {in}) = A –13.9 {0.547}

4.  Verify that the clearance between the rear ABS sensor rotor and the rear ABS wheel-speed sensor is as indicated below.

•  If there is any malfunction, replace it.
Clearance
0.88 mm {0.035 in} or less


Sensor Output Value Inspection

Caution
•  Resistance inspection using other testers may cause damage to the ABS wheel-speed sensor internal circuit. Be sure to use the M-MDS to inspect the ABS wheel-speed sensor.

1.  Switch the ignition to off.

2.  Connect the M-MDS to the DLC-2.

am3zzn00002365

3.  Select the following PIDs using the M-MDS:

•  WSPD_LR
(LR wheel-speed sensor)
•  WSPD_RR
(RR wheel-speed sensor)

4.  Start the engine and drive the vehicle.

5.  Verify that the display of the M-MDS shows the same value as the speedometer.

•  If there is any malfunction, replace the rear ABS wheel-speed sensor.