DTC P0706:00 [FN4A-EL]

id050218817000

DTC P0706:00

TR switch circuit range/performance
DETECTION CONDITION
•  The PCM detects no position/range signal for 100 s when the following conditions are met.
―  Vehicle speed: 20 km/h {12 mph} or more
―  Engine speed: 530 rpm or more
―  Input voltage from the TR switch: 0.49 V or more
Diagnostic support note
•  The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
•  The AT warning light illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
•  PENDING CODE is available.
•  FREEZE FRAME DATA is available.
•  The DTC is stored in the PCM memory.
POSSIBLE CAUSE
•  TR switch maladjustment
•  TR switch malfunction
•  PCM malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION
1
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
•  Has the FREEZE FRAME DATA been recorded on the repair order?
Yes
Go to the next step.
No
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
•  Verify related Service Information availability.
•  Is any related repair information available?
Yes
Perform repair or diagnosis according to the available repair information.
•  If the vehicle is not repaired, go to the next step.
No
Go to the next step.
3
INSPECT TR SWITCH
•  Inspect the TR switch.
•  Is there any malfunction?
Yes
Adjust or replace the TR switch, then go to the next step.
(See TRANSAXLE RANGE (TR) SWITCH ADJUSTMENT [FN4A-EL].)
(See TRANSAXLE RANGE (TR) SWITCH REMOVAL/INSTALLATION [FN4A-EL].)
No
Go to the next step.
4
VERIFY DTC TROUBLESHOOTING COMPLETED
•  Make sure to reconnect all the disconnected connectors.
•  Clear the DTC using the M-MDS.
•  Perform the following procedure to ensure that the DTC has been resolved:
1.  Drive the vehicle at 20 km/h {12 mph} or more for 100 s or more.
•  Is the PENDING CODE same as the DTC present?
Yes
Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [FN4A-EL].)
No
Go to the next step.
5
VERIFY NO DTCs ARE PRESENT
•  Perform the “Reading DTCs Procedure”.
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [FN4A-EL].)
No
DTC troubleshooting completed.