ON-BOARD DIAGNOSTIC SYSTEM SIMULATION INSPECTION [FS5A-EL]

id050221290400

1.  Connect the M-MDS (IDS) to the DLC-2.

am3uuw00002615

2.  After the vehicle is identified, select the following items from the initialization screen of the IDS.

1.  Select "DataLogger".
2.  Select "Modules".
3.  Select "TCM".

3.  Select the simulation items from the PID table.

4.  Perform the simulation function, inspect the operations for each parts.

•  If the operation of output parts cannot be verified after the active command mode inspection is performed, this could indicate the possibility of an open or short circuit, sticking, or operation malfunction in the output parts.

Simulation table

Item

Related to

Unit/Condition

Test condition
LPS
Pressure control solenoid A
A
Idling at P or N position
LPSB
Pressure control solenoid B
%
Idling at P or N position
SSA/SS1
Shift solenoid A
%
Idling at P or N position
SSB/SS2
Shift solenoid B
%
Idling at P or N position
SSC/SS3
Shift solenoid C
%
Idling at P or N position
SSD/SS4
Shift solenoid D
On/Off
Idling at P or N position
SSE_SS5
Shift solenoid E
On/Off
Idling at P or N position
SSF_SS6
Shift solenoid F
On/Off
Idling at P or N position