CLUTCH MASTER CYLINDER REMOVAL/INSTALLATION [B76M-R]

id0510001568m9

Caution
•  Do not allow clutch fluid get on a painted surface. Clutch fluid contains properties which can dissolve the paint. If clutch fluid gets on a painted surface, wash it off with water immediately and wipe the area off completely.

1.  Disconnect the negative battery cable.

2.  Remove the battery component. (ex: battery, battery tray) (L.H.D.) (See BATTERY REMOVAL/INSTALLATION [MZ-CD 1.6].)

3.  Remove the clutch pedal position switch. (See CLUTCH PEDAL POSITION SWITCH REMOVAL/INSTALLATION [B76M-R].)

4.  Disconnect the clutch pipe and hose No.1 from clutch master cylinder, and plug it to avoid leakage. (See CLUTCH PIPE AND HOSE REMOVAL/INSTALLATION [B76M-R].)

5.  Disconnect the clutch reserve hose from clutch master cylinder, and plug it to avoid leakage. (See CLUTCH PIPE AND HOSE REMOVAL/INSTALLATION [B76M-R].)

6.  Remove the clutch pedal installation nuts.

am5uuw00003716

Tightening torque
19—25 N·m {2.0—2.5 kgf·m, 15—18 ft·lbf}

7.  Remove the clutch master cylinder.

(1)  Disconnect the clutch master cylinder (rubber) from the body.
(2)  Rotate the clutch master cylinder in the direction of the arrow shown in the figure to disconnect the clutch master cylinder (body) and clutch pedal.
am5ezw00006651
(3)  Disengage the tabs of the push rod and remove the master cylinder using a flathead screwdriver.
am5ezw00006652

8.  Install the clutch master cylinder.

(1)  Insert the clutch master cylinder into the installation hole of the body.
(2)  Insert the stud bolt into the installation hole of the clutch pedal.
am5uuw00003717
(3)  Engage the tabs of the push rod with the clutch pedal as shown in the figure.
am5uuw00003622
(4)  Rotate the clutch master cylinder in the direction shown until it stops.
am5ezw00006654
(5)  Install the clutch master cylinder (rubber) to the body.

9.  Install in the reverse order of removal.

10.  Bleed the air from the clutch system. (See CLUTCH FLUID REPLACEMENT/AIR BLEEDING [B76M-R].)

11.  Fully depress the clutch pedal, and verify that the engine starts.