TRANSAXLE RANGE (TR) SWITCH ADJUSTMENT [DJVA-EL]

id051901288100

Caution

•  Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.

1.  Select the selector lever to N position.

2.  Perform the following procedures.

(1)  Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)

(2)  Disconnect the negative battery cable.

(3)  Disconnect the TR switch connector.

am3zzw00008253

3.  Loosen the TR switch.

(1)  Remove the clip, and then disconnect the selector cable end from the manual shaft lever.

adejjw00004771

(2)  Loosen the TR switch installation bolts.

adejjw00002811

4.  Adjust the TR switch.

(1)  Rotate the manual shaft in the clockwise direction until it stops, and from that position, rotate it counterclockwise 2 notches to the N position.

(2)  Rotate the TR switch and align the projection of the nut stopper with the neutral reference line.

(3)  Tighten the TR switch installation bolts.

Tightening torque

6.9 N·m {70 kgf·cm, 61 in·lbf}

(4)  Verify that the projection of the nut stopper is aligned with the neutral reference line.

5.  Inspect the TR switch using a tester.

am3zzw00010448

•  If there is any malfunction, replace the TR switch. (See TRANSAXLE RANGE (TR) SWITCH REMOVAL/INSTALLATION [DJVA-EL].)

am3zzw00008731