DTC C1280, C1282, C2770

id080200001100


System Malfunction Location

DTC

System Malfunction Location

M-MDS display
C1280
Yaw rate sensor in SAS control module is signal error
C1282
Low-G (XY) sensor (lateral-G) in SAS control module is signal error
C2770
Low-G (XY) sensor (forward-G) in SAS control module is signal error


Detection Condition

Warning
•  Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.
•  Malfunction in the SAS control module

Possible Causes

•  SAS control module malfunction

Diagnostic Procedure

Step

Inspection

Action
1
PERFORM SAS CONTROL MODULE DTC INSPECTION
•  Clear the DTC for the SAS control module using the M-MDS. (See CLEARING DTC.)
•  Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC INSPECTION.)
•  Are the same DTCs present?
Yes
Replace the SAS control module.
(See SAS CONTROL MODULE REMOVAL/INSTALLATION.)
No
DTC troubleshooting completed.