DTC INSPECTION [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)]
id09021d960300
Verifying DTCs using security light
1. Switch the ignition ON.
2. Wait for approx. 1 min until the security light displays a DTC.
3. Read DTCs by the number of times the security light flashes as shown in the figure.
Example: DTC 12
am3uuw00008370
|
4. Repair the malfunctioning part according to the applicable DTC troubleshooting based on the DTC which was verified by the number of times the security light flashed. (See DTC TABLE [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)].)
Detecting DTC using the M-MDS
1. Connect the M-MDS (IDS) to the DLC-2.
am3uuw00002664
|
2. After the vehicle is identified, select the following items from the initialization screen of the IDS.
3. Verify the DTC according to the directions on the screen.
4. After completion of repairs, clear all DTCs stored in the module using the M-MDS. (See CLEARING DTC [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)].)