DTC INSPECTION [INSTRUMENT CLUSTER]

id0902e8960300

1.  Connect the M-MDS (IDS) to the DLC-2.

am3zzw00010894

2.  After the vehicle is identified, select the following items from the initialization screen of the IDS.

(1)  Select “Self Test”.
(2)  Select “Modules”.
(3)  Select “IC”.

3.  Verify the DTC according to the directions on the screen.

•  If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection after recording the snapshot data.

4.  After completion of repairs, clear all DTCs stored in the instrument cluster. (See CLEARING DTC [INSTRUMENT CLUSTER].)


Snapshot Data Table

Note
•  Snapshot data items are not displayed, according to detected DTC.

Snapshot data item

Unit

Definition
TOTAL_DIST
km, ft {mi}
Display odometer reading when DTC is detected (four-digit number indicated).
VSS*
KPH, MPH
Display vehicle speed when DTC is detected.
WU1_P*
KPa {MPa}, mBar {Bar}, psi, in H20
Display tire pressure when DTC is detected. (Wheel unit No.1)
WU1_T*
°C, °F
Display tire temperature when DTC is detected. (Wheel unit No.1)
WU2_P*
KPa {MPa}, mBar {Bar}, psi, in H20
Display tire pressure when DTC is detected. (Wheel unit No.2)
WU2_T*
°C, °F
Display tire temperature when DTC is detected. (Wheel unit No.2)
WU3_P*
KPa {MPa}, mBar {Bar}, psi, in H20
Display tire pressure when DTC is detected. (Wheel unit No.3)
WU3_T*
°C, °F
Display tire temperature when DTC is detected. (Wheel unit No.3)
WU4_P*
KPa {MPa}, mBar {Bar}, psi, in H20
Display tire pressure when DTC is detected. (Wheel unit No.4)
WU4_T*
°C, °F
Display tire temperature when DTC is detected. (Wheel unit No.4)

*  :Vehicles with tire pressure monitoring system