STEERING ANGLE SENSOR INITIALIZATION PROCEDURE
id091800813500
-
Note
-
• If the negative battery cable is disconnected, perform the steering angle sensor initialization procedure.
1. Inspect the wheel alignment, inflation pressure, and the installation condition of the steering wheel.
-
• If there is any malfunction, adjust the applicable part.
2. Start the engine.
3. Turn the steering wheel to full right lock, then turn it to full left lock.
-
Note
-
• The steering wheel can be turned first to the left or right.
• If the steering wheel is turned in the opposite direction before it locks, the correct steering angle will not be stored in memory.
4. Switch the ignition OFF (LOCK).