REAR VEHICLE MONITORING CONTROL MODULE CONFIGURATION

id092200014800

Note

•  Configuration is necessary when replacing the rear vehicle monitoring control module (RH).Configuration is not necessary when replacing the rear vehicle monitoring control module (LH).

1.  Connect the M-MDS (IDS) to the DLC-2.

am3uuw00002620

2.  After the vehicle is identified, select the following items from the initialization screen of the IDS.

1.  Select “Module Programming”

3.  Then, select items from the screen menu in the following order.

1.  Select “Programmable Module Installation”

2.  Select “RVM”

4.  Perform the configuration following the instructions on the screen.

5.  Retrieve DTCs by the M-MDS (IDS), then verify that there is no DTC present.

•  If a DTC(s) is detected, perform the applicable DTC inspection. (See DTC TABLE [REAR VEHICLE MONITORING SYSTEM].)