APRON REINFORCEMENT (PARTIAL CUTTING) INSTALLATION [PANEL REPLACEMENT]

id098008741600

Symbol Mark

am3uub00000136

Installation procedure

1.  When installing new parts, measure and adjust the body as necessary to conform with standard dimensions.

2.  Drill holes for the plug welding before installing the new parts.

3.  After temporarily installing new parts, make sure the related parts fit properly.

4.  Spot weld the 1 location indicated by (E) shown in the figure while install the apron gusset in apron reinforcement upper. (RH only)

am3uub00000287

5.  Cut and joint at the locations indicated by (A) shown in the figure to install the new parts.

am3uub00000137

6.  Cut and joint at the locations indicated by (B) shown in the figure to install the new parts.

7.  Spot weld the 10 locations indicated by (C) shown in the figure.

am3uub00000250

8.  Plug weld the 3 locations indicated by (D) shown in the figure while install the front fender bracket front.

am3uub00000251