ON-BOARD DIAGNOSTIC SYSTEM ACTIVE COMMAND MODES FUNCTION [SKYACTIV-D 1.5]


id0102q2105400

Note
•  Simulation items on parts which are not equipped to the vehicle do not operate.
•  When the engine conditions and the other conditions have been met, the simulation item can be operated.
•  The simulation items are shown below.

Simulation item table

Item

Applicable component

Unit/Condition

Engine condition

Other condition

ACCS
A/C relay
Off/On
•  Under the following conditions:
―  Ignition is switched ON (engine off)
Not applicable
ARPMDES
Target engine speed
RPM
•  Under the following conditions:
―  Idle
Not applicable
CCV_DSD
Coolant control valve desired value
°(deg)
•  Under the following conditions:
―  Ignition is switched ON (engine off)
Not applicable
E_WP
Electric water pump control duty value
%
•  Under the following conditions:
―  Ignition is switched ON (engine off)
―  Idle
Not applicable
EXHSHUT_DSD
Exhaust shutter valve desired value
%
•  Under the following conditions:
―  Ignition is switched ON (engine off)
―  Idle
Not applicable
FAN_DUTY
Fan control module duty cycle
%
•  Under the following conditions:
―  Ignition is switched ON (engine off)
―  Idle
Not applicable
HPEGR_DSD
HP-EGR control valve desired value
%
•  Under the following conditions:
―  Ignition is switched ON (engine off)
Not applicable
INJ_1*1
Fuel injector No.1
OFF
•  Under the following conditions:
―  Idle
•  Under the following conditions:
―  Vehicle speed: 0 km/h {0 mph}
INJ_2*1
Fuel injector No.2
OFF
INJ_3*1
Fuel injector No.3
OFF
INJ_4*1
Fuel injector No.4
OFF
ISV_DSD
Intake shutter valve control desired value
°(deg)
•  Under the following conditions:
―  Ignition is switched ON (engine off)
Not applicable
LPEGR_DSD
LP-EGR control valve desired value
%
•  Under the following conditions:
―  Ignition is switched ON (engine off)
―  Idle
Not applicable
VGTURB_DSD
Turbocharger with variable turbine geometry position desired value
%
•  Under the following conditions:
―  Idle
Not applicable

*1  :By using these items, freeze frame data may be overwritten when a DTC is detected. Obtain the freeze frame data before using these items. In addition, clear the DTC if a DTC is detected.