FLYWHEEL INSPECTION [F66M-R]

id0510q2157700

1.  Remove the flywheel. (See CLUTCH UNIT REMOVAL/INSTALLATION [F66M-R].)

2.  Perform the following procedure to inspect the flywheel.

•  If there is any malfunction or it exceeds the maximum specification, replace the flywheel. (See CLUTCH UNIT REMOVAL/INSTALLATION [F66M-R].)

(1)  Inspect the surface that contacts the clutch disc for scratches, nicks, and discoloration.

am3uuw00002076

•  Correct slight scratches and discoloration using sandpaper.

(2)  Inspect the ring gear teeth for damage and wear.

•  If there is any malfunction, replace the flywheel.

(3)  Inspect the runout of the surface that contacts the clutch disc.

am3uuw00008268

1)  Install the flywheel. (See CLUTCH UNIT REMOVAL/INSTALLATION [F66M-R].)

2)  Measure the runout of the surface that contacts the clutch disc using a dial gauge.

Flywheel maximum runout

0.1 mm {0.004 in}

•  If it exceeds the maximum specification, replace the flywheel. (See CLUTCH UNIT REMOVAL/INSTALLATION [F66M-R].)