|
DTC No.
|
On-board diagnostic function
|
Detection condition
|
Fail-safe
|
TCC
|
|
P0500
|
VSS circuit malfunction
|
• No VSS signal is input to PCM terminal 1AY (ZY, Z6)/1J (LF, L3) when engine coolant temperature is 60 °C {140 °F} or more and input/turbine speed sensor signal is above 1,500 rpm and selector lever position is at D or M range.
|
N/A
|
Enabled
|
|
P0706
|
Transaxle range (TR) switch circuit range/performance
|
• No TR signal (P, R, N or D range/position) Input to PCM terminal 1X (ZY, Z6)/1S (LF, L3) when engine speed is 530 rpm or more and vehicle speed is 20 km/h {12 mph} or more and voltage at PCM terminal 1X (ZY, Z6)/1S (LF, L3) is 0.5 V or more.
|
• Inhibits gear shifting and maximizes line pressure
|
Disabled
|
|
P0707
|
Transaxle range (TR) switch circuit low input
|
• Input voltage from TR switch to PCM terminal 1X (ZY, Z6)/1S (LF, L3) 0.5 V or less when engine speed is 530 rpm or more and vehicle speed is 20 km/h {12 mph} or more.
|
• Inhibits gear shifting and maximizes line pressure
|
Disabled
|
|
P0708
|
Transaxle range (TR) switch circuit high input
|
• Input voltage from TR switch to PCM terminal 1X (ZY, Z6)/1S (LF, L3) 4.79 V or more when engine speed is 530 rpm or more and vehicle speed is 20 km/h {12 mph} or more.
|
• Inhibits gear shifting and maximizes line pressure
|
Disabled
|
|
P0711
|
Transaxle fluid temperature (TFT) sensor circuit range/performance (Stuck)
|
• Input voltage from TFT sensor to PCM terminal 1AU (ZY, Z6)/1U (LF, L3) and 1AN (ZY, Z6)/1AA (LF, L3) maintains 0.06 V or less when 180 s have passed after engine is started, vehicle is driven for 150 s or more at vehicle speed between 25 and 59 km/h {15 and 36 mph}, then 60 km/h {37 mph} or more for 100 s or more.
|
N/A
|
Disabled
|
|
P0712
|
Transaxle fluid temperature (TFT) sensor circuit malfunction (short to ground)
|
• Input voltage from TFT sensor to PCM terminal 1AU (ZY, Z6)/1U (LF, L3) and 1AN (ZY, Z6)/1AA (LF, L3) maintains 0.06 V or less when vehicle speed is 20 km/h {12 mph} or more.
|
• Sets temperature to cold condition
|
Disabled
|
|
P0713
|
Transaxle fluid temperature (TFT) sensor circuit malfunction (open circuit)
|
• Input voltage from TFT sensor to PCM terminal 1AU (ZY, Z6)/1U (LF, L3) and 1AN (ZY, Z6)/1AA (LF, L3) maintains 4.67 V or more when vehicle speed is 20 km/h {12 mph} or more.
|
• Sets temperature to cold condition
|
Disabled
|
|
P0715
|
Input/turbine speed sensor circuit malfunction
|
• No input/turbine speed sensor signal to PCM terminals 1O (ZY, Z6)/1M (LF, L3) and 1K (ZY, Z6)/1Q (LF, L3) when vehicle speed is 40 km/h {25 mph} or more and selector lever position is at D or M range.
|
• Inhibits 4GR
|
Disabled
|
|
P0731
|
Gear 1 incorrect (incorrect gear ratio detected)
|
• Revolution ratio of forward clutch drum revolution to differential gear case revolution is 2.16 or less while in 1GR.
|
• Inhibits 1GR and maximizes line pressure
|
Enabled
|
|
P0732
|
Gear 2 incorrect (incorrect gear ratio detected)
|
• Revolution ratio of forward clutch drum revolution to differential gear case revolution is 1.25 or less or 2.16 or more while in 2GR.
|
• Inhibits 2GR and maximizes line pressure
|
Enabled
|
|
P0733
|
Gear 3 incorrect (incorrect gear ratio detected)
|
• Revolution ratio of forward clutch drum revolution to differential gear case revolution is 0.86 or less or 1.25 or more while in 3GR.
|
N/A
|
Enabled
|
|
P0734
|
Gear 4 incorrect (incorrect gear ratio detected)
|
• Revolution ratio of forward clutch drum revolution to differential gear case revolution is 0.6 or less or 1.25 or more while in 4GR.
|
• Inhibits 4GR and maximizes line pressure
|
Disabled
|
|
P0741
|
Torque converter clutch (TCC) (stuck off)
|
• Difference between engine speed and turbine speed more than 100 rpm while TCC is operating.
|
• Inhibits TCC and maximizes line pressure
|
Disabled
|
|
P0742
|
Torque converter clutch (TCC) (stuck on)
|
• Difference between engine speed and turbine speed 50 rpm or less while TCC is not operating.
|
• Inhibits TCC and maximizes line pressure
|
Disabled
|
|
P0745
|
Pressure control solenoid malfunction
|
• If voltage is stuck at 0 V or B+ in pressure control solenoid control terminal 1AF (ZY, Z6)/1G (LF, L3) of the PCM when the solenoid valve operates according to PCM calculation.
|
N/A
|
Enabled
|
|
P0751
|
Shift solenoid A stuck off
|
• Revolution ratio of forward clutch drum revolution to differential gear case revolution within 0.91-1.09 in 4GR and DTCs not output
|
• Inhibits 4GR and TCC and maximizes line pressure
|
Disabled
|
|
P0752
|
Shift solenoid A stuck on
|
• Input/turbine speed sensor signal 187.5 rpm or above in D range
|
• Inhibits 1GR, 2GR, and 3GR and maximizes line pressure
|
Enabled
|
|
P0753
|
Shift solenoid A malfunction (electrical)
|
• If voltage is stuck at 0 V or B+ in shift solenoid A control terminal 1AZ (ZY, Z6)/1B (LF, L3) of the PCM when the solenoid valve operates according to PCM calculation.
|
• Inhibits 4GR and TCC and maximizes line pressure
|
Disabled
|
|
P0756
|
Shift solenoid B stuck off
|
• Revolution ratio of forward clutch drum revolution to differential gear case revolution 2.157 or less in 1GR and DTCs not output.
|
• Inhibits 1GR and 4GR and maximizes line pressure
|
Enabled
|
|
P0757
|
Shift solenoid B stuck on
|
• Revolution ratio of forward clutch drum revolution to differential gear case revolution 1.249 or less or more than 2.157 in D range 2GR.
• Revolution ratio of forward clutch drum revolution to differential gear case revolution 0.6 or less or more than 1.249 in D range 4GR.
|
• Inhibits 2GR and 4GR and maximized line pressure
|
Enabled
|
|
P0758
|
Shift solenoid B malfunction (electrical)
|
• If voltage is stuck at 0 V or B+ in shift solenoid B control terminal 1BH (ZY, Z6)/1C (LF, L3) of the PCM when the solenoid valve operates according to PCM calculation.
|
• Inhibits 1GR and 4GR and maximizes line pressure
|
Enabled
|
|
P0761
|
Shift solenoid C stuck off
|
• Revolution ratio of forward clutch drum revolution to differential gear case revolution 2.157 or less in D range 1GR and 2GR.
|
• Inhibits 1GR and 2GR and maximizes line pressure
|
Enabled
|
|
P0762
|
Shift solenoid C stuck on
|
• Revolution ratio of forward clutch drum revolution to differential gear case revolution 0.863 or less or 1.249 or more in D range 3GR.
• Revolution ratio of forward clutch drum revolution to differential gear case revolution 0.6 or less or 1.249 or more in D range 4GR.
|
• Inhibits 3GR and 4GR and maximizes line pressure
|
Enabled
|
|
P0763
|
Shift solenoid C malfunction (electrical)
|
• If voltage is stuck at 0 V or B+ in shift solenoid C control terminal 1BD (ZY, Z6)/1D (LF, L3) of the PCM when the solenoid valve operates according to PCM calculation.
|
• Inhibits 1GR and 2GR and maximizes line pressure
|
Enabled
|
|
P0766
|
Shift solenoid D stuck off
|
• Revolution ratio of forward clutch drum revolution to differential gear case revolution 0.6 or less or 1.249 or more in D range 4GR.
|
• Inhibits 4GR and maximizes line pressure
|
Enabled
|
|
P0767
|
Shift solenoid D stuck on
|
• Revolution ratio of forward clutch drum revolution to differential gear case revolution 0.863 or less or 1.249 or more in D range 3GR.
|
• Inhibits 2GR, 4GR, and TCC and maximizes line pressure
|
Disabled
|
|
P0768
|
Shift solenoid D malfunction (electrical)
|
• If voltage is stuck at 0 V or B+ in shift solenoid D valve control terminal 1AJ (ZY, Z6)/1E (LF, L3) of the PCM when the solenoid valve operates according to PCM calculation.
|
• Inhibits 4GR and maximizes line pressure
|
Enabled
|
|
P0771
|
Shift solenoid E stuck off
|
• Difference between engine speed and turbine speed more than 100 rpm in driving in 4GR at D range TCC operation.
|
• Inhibits TCC and maximized line pressure
|
Disabled
|
|
P0772
|
Shift solenoid E stuck on
|
• Difference between engine speed and turbine speed 50 rpm or less in driving in 4GR at D range while TCC is not operating.
|
• Inhibits 1GR and maximizes line pressure
|
Enabled
|
|
P0773
|
Shift solenoid E malfunction (electrical)
|
• If voltage is stuck at 0 V or B+ in shift solenoid E control terminal 1AR (ZY, Z6)/1F (LF, L3) of the PCM when the solenoid valve operates according to PCM calculation.
|
• Inhibits TCC and maximized line pressure
|
Disabled
|
|
P0841
|
Oil pressure switch circuit malfunction
|
• No oil pressure switch signal input when revolution ratio of forward clutch drum revolution to differential gear case revolution is 0.91 or less or 3.08 or more while in 1, 2 or 3GR.
• Oil pressure switch signal input when revolution ratio of forward clutch drum revolution to differential gear case revolution is 0.64 or less or 0.82 or more while in 4GR.
|
N/A
|
Enabled
|
|
P0894
|
Forward clutch torque transmission
|
• Turbine speed does not fall to less than 187 rpm 3 s or more after starting the engine with the vehicle in the D or M range and stopped (brake applied).
|
• Driving restricted to 4GR
|
Enabled
|