DTC B2856, B2886, B2887 [STANDARD DEPLOYMENT CONTROL SYSTEM]
id0802b1811600
DTC
B2856
Crash zone sensor ID mismatch
B2886
Passenger-side side air bag sensor ID mismatch
B2887
Driver-side side air bag sensor ID mismatch
DETECTION CONDITION
Warning
• Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.
• The SAS control module detects an error of impact magnitude set in the sensor, which occurs due to installation mismatch of the crash zone sensor or side air bag sensors.
POSSIBLE CAUSE
• Crash zone sensor misinstalled with wrong sensor
• Driver-side side air bag sensor misinstalled with wrong sensor
• Passenger-side side air bag sensor misinstalled with wrong sensor
Diagnostic procedure
STEP
INSPECTION
ACTION
1
INSPECT EACH SENSOR FOR INSTALLATION POSITION
• Verify that the crash zone sensor or side air bag sensor is installed in the correct position.
• Is each sensor installed correctly?
Yes
Go to the next step.
No
Install the each sensor correctly, then go to the next step.