HIGH PRESSURE FUEL PUMP INSPECTION [MZR 2.0 DISI]

id0114d4801500

Note

•  The following vacuum values are indicated by relative pressure from the fuel pressure sensor.

1.   Verify that the fuel pressure sensor is normal. (See FUEL PRESSURE SENSOR REMOVAL/INSTALLATION [MZR 2.0 DISI].)

2.  Connect the M-MDS to the DLC-2.

am6zzw00005211

3.  Switch the ignition to ON.

4.   Select the FUEL_PRES, and LOAD, RPM PIDs on the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [MZR 2.0 DISI].)

Caution

•  If the engine is run at a high speed, it could be damaged. When racing the engine, do not race it up to 6,700 rpm or more.

5.  After the LOAD PID is 60% or more while the engine is raced with the accelerator pedal fully depressed, verify that the FUEL_PRES PID is approx. 11.5MPa.

―  If not as verified, replace the high pressure fuel pump. (See HIGH PRESSURE FUEL PUMP REMOVAL/INSTALLATION [MZR 2.0 DISI].)