CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTION [MZR 2.0 DISI]

id0140j3801600

1.  Verify that the CPP switch is installed properly.

2.  Disconnect the negative battery cable.

3.  Disconnect the CPP switch connector. (See CLUTCH PEDAL REMOVAL/INSTALLATION [G66M-R].)

4.  Inspect for continuity between the CPP switch terminals using an ohmmeter.

am3uuw00002798

•  If not as specified, replace the CPP switch.
(See CLUTCH PEDAL REMOVAL/INSTALLATION [G66M-R].)

Specification

Measured condition

Clutch pedal position

Continuity
Rod pushed
Clutch pedal released
Continuity detected
Except above
Clutch pedal depressed
No continuity