REAR BRAKE (DISC) REMOVAL/INSTALLATION

id041100800500

1.  Remove in the order indicated in the table.

2.  Install in the reverse order of removal.

3.  Add brake fluid, bleed the brakes, and inspect for leakage after the installation has been completed. (See AIR BLEEDING.)

4.  After installation, depress the pedal several times, rotate the wheel by hand, and verify that the brake does not drag.

am6zzw00005008

1	Parking brake cable, clip
2	Bolt
3	Flexible hose
4	Bolt
5	Caliper
6	Spring
7	Disc pad (See Guide Plate, Shim, Disc Pad Installation Note.)
8	Shim (See Guide Plate, Shim, Disc Pad Installation Note.)
9	Mounting support
10	Disc plate

Guide Plate, Shim, Disc Pad Installation Note

Warning

•  Never apply grease to the disc plate and disc pad surfaces as it will cause the brakes to become ineffective resulting in an unexpected accident.

1.  Push and turn clockwise the piston fully inward using the SST.

am6zzw00005009

2.  Perform the following procedure only when replacing the disc pads or shims.

Note

•  Apply a thin layer of grease to the entire area without going outside of the specified area.

(1)  Apply the grease, which is in the packaging with the lettering, to the contact area of the guide plate mounting support.

am6zzw00005010

(2)  Apply the grease, which is not in the packaging with the lettering, to the contact area of the disc pad guide plate.

(3)  Apply the grease, which is in the packaging with the lettering, between the shims.

3.  Install the guide plate to the mounting support.

4.  Install the shim and disc pads.