DTC INSPECTION [AFS (ADAPTIVE FRONT LIGHTING SYSTEM)]

id0902g9960300

Without M-MDS (Reading by AFS OFF light flashing pattern)

1.  Switch the ignition to off.

2.  Set a jumper wire to the DLC-2 B terminal.

am6zzw00005400

3.  Switch the ignition to ON.

4.  Turn the light switch to the LO position.

5.  Connect the DLC-2 terminal B to ground using a jumper wire.

Caution

•  If the terminals are mistakenly connected, vehicle damage or fire could occur. When connecting with the jumper wire, thoroughly verify what terminals are being connected to prevent a miss-connection.

6.  Verify that the motor inside the headlight leveling actuator operates and the headlight optical axis lowers from its current position and returns to its original position.

Note

•  If the motor inside the headlight leveling actuator does not operate, the headlight optical axis may be at the bottommost position, or the procedure may have been performed incorrectly. Therefore, park the vehicle on level ground and resume the procedure from Step 1.

7.  Read the DTCs by the flashing pattern of the AFS OFF light.

am6zzw00006144

8.  After verifying the DTCs, pull out the jumper wire from DLC-2.

With M-MDS

1.  Connect the M-MDS (IDS) to the DLC-2.

am6zzw00001759

2.  After the vehicle is identified, select the following items from the initialization screen of the IDS.

(1)  Select “Self Test”.

(2)  Select “Modules”.

(3)  Select “AFS”.

3.  Verify the DTC according to the directions on the screen.

•  If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.

4.  After completion of repairs, clear all DTCs stored in the AFS control module. (See CLEARING DTC [AFS (ADAPTIVE FRONT LIGHTING SYSTEM)].)