SECURITY AND LOCKS PERSONALIZATION FEATURES

id091400590200

•  A personalization features that switches the activation/deactivation of each function has been adopted.
•  The setting of the following system functions, and warning and guidance functions can be turned ON/OFF optionally.
•  The Mazda Modular Diagnostic System (M-MDS) is required to perform the setting. Refer to the Workshop Manual for the detailed setting procedure.

Advanced Keyless Entry And Push Button Start System

Mazda Modular Diagnostic System (M-MDS) display

Function

Initial setting

Setting content

Control unit
Advanced keyless function
Advanced keyless entry and push button start system function can be set to inoperable.
Enabled
Disabled/ Enabled
Keyless control module
Prevention function of key Containment in Trunk or Liftgate
Key-left-in-trunk prevention function can be set.
Disabled
Disabled/ Enabled
Keyless control module
ACC auto off
The function to automatically switch off the ignition after one hour has elapsed since the ignition was switched to ACC can be set to operable or inoperable.
Enabled
Disabled/ Enabled
Keyless control module
Power off mode
The transition pattern in which the ignition position is switched by pressing the push button start can be selected.
Direct
Direct/Stepwise
Keyless control module
Advanced key battery low warning
Advanced key remaining battery level/battery dead warning can be set.
Enabled
Disabled/ Enabled
Keyless control module
Answer back buzzer volume
Volume adjustment of the answer back buzzer can be set.
European (L.H.D. U.K.) specs.
•  Disabled
Except above
•  5*1
Disabled/ 4-10
Keyless control module
Warning buzzer volume
Volume adjustment of the warning buzzer can be set.
8*2
5-10
Keyless control module
Auto lock
Auto lock function can be set.
Disabled
Disabled/Enabled
Keyless control module

*1  :Depending on the vehicle, the initial value of the answer back buzzer volume may be 4. if the answer back buzzer volume is reset to the initial value, set the value according to the table.
*2  :Depending on the vehicle, the initial value of the warning buzzer volume may be 10. if the warning buzzer volume is reset to the initial value, set the value according to the table.