REAR VEHICLE MONITORING CONTROL MODULE CONFIGURATION

id092200165300

Note

•  Configuration is necessary when replacing the rear vehicle monitoring control module (RH).Configuration is not necessary when replacing the rear vehicle monitoring control module (LH).

1.  Connect the M-MDS(IDS) to the DLC-2.

am6zzw00003757

2.  After the vehicle is identified, select “Module Programming” from the initial screen of the IDS.

3.  Select “Programmable Module Installation”, then select “RVM” from the screen menu.

4.  Perform the configuration following the instructions on the screen.

5.  Verify that no DTCs are stored. (See DTC TABLE [REAR VEHICLE MONITORING SYSTEM].)