INSTRUMENT CLUSTER CONFIGURATION

id092200800300

1.  Connect the M-MDS (IDS) to the DLC-2.

am6zzw00000768

2.  After the vehicle is identified, select “Module Programming” from the initial screen of the IDS.

3.  Select “Programmable Module Installation”, then select “IC” from the screen menu.

4.  Perform the configuration according to the directions on the screen.

5.  Verify that no DTCs are displayed.

•  If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER].)