ACCELERATOR PEDAL POSITION (APP) SENSOR INSPECTION [SKYACTIV-G 2.5T]

id0140h0803200

Note
•  The APP sensor is built into the accelerator pedal. When replacing the APP sensor, replace the accelerator pedal.

Function Inspection

1.  Connect the M-MDS to the DLC-2.

2.  Switch the ignition ON (engine off).

3.  Display the PIDs APP1 and APP2. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5T)].) (See PCM INSPECTION [SKYACTIV-G 2.5T].)

4.  Compare the voltage and opening angle indications for the PIDs APP1 and APP2 with the standard in the table indicated below.

•  If they do not match the standard, perform the voltage inspection. (See Voltage Inspection.)

Standard

Condition/

APP1

APP2

V

%

V

%
Accelerator pedal released
Approx. 0.78
Approx. 16
Approx. 0.39
Approx. 7.84
Accelerator pedal depressed
Approx. 4.54
Approx. 91
Approx. 2.27
Approx. 45.49


Voltage Inspection

1.  Connect the M-MDS to the DLC-2.

2.  Switch the ignition ON (engine off).

3.  Verify that the APP sensor output voltage (PID: APP1, APP2) increases according to the increase in the accelerator opening angle when the accelerator opening angle is gradually increased. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5T)].)

•  If verified, go to the next step.
•  If not as verified, replace the accelerator pedal. (See ACCELERATOR PEDAL REMOVAL/INSTALLATION [SKYACTIV-G 2.5T].)

4.  Verify that the APP sensor output voltage (PID: APP1, APP2) is within the specification when the accelerator pedal is depressed and not depressed. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5T)].) (See PCM INSPECTION [SKYACTIV-G 2.5T].)

•  If not as specified, replace the accelerator pedal. (See ACCELERATOR PEDAL REMOVAL/INSTALLATION [SKYACTIV-G 2.5T].)

Specification (Reference)

ac9uuw00007708