COOLANT CONTROL VALVE POSITION SENSOR INSPECTION [SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION)]

id0140h3498000

Note

•  The coolant control valve position sensor is built into the coolant control valve. When replacing the coolant control valve position sensor, replace the coolant control valve.

PID/DATA Monitor Inspection

1.  Connect the M-MDS to the DLC-2.

2.  Switch the ignition ON (engine off).

3.  Display PIDs ENG_CL_V_POS and ENG_CL_V_POS_R using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION))].) (See PCM INSPECTION [SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION)].)

4.  When the engine is started after switching the ignition ON (engine off), verify that the PID ENG_CL_V_POS_R value conforms to the PID ENG_CL_V_POS value.

•  If not as verified, replace the coolant control valve (See COOLANT CONTROL VALVE REMOVAL/INSTALLATION [SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION)].)