DTC C2011:87/C2012:87/C2013:87/C2014:87 [INSTRUMENT CLUSTER (TPMS)]
id020210811700
|
DTC |
C2011:87 |
Communication error to wheel unit No.1 |
|---|---|---|
|
C2012:87 |
Communication error to wheel unit No.2 |
|
|
C2013:87 |
Communication error to wheel unit No.3 |
|
|
C2014:87 |
Communication error to wheel unit No.4 |
|
|
DETECTION CONDITION
|
• Communication error to wheel unit is detected at a speed of 25 km/h {16 mph} or more.
|
|
|
FAIL-SAFE FUNCTION
|
• Refer to “Fail-safe function table”. (See DTC TABLE [INSTRUMENT CLUSTER (TPMS)].)
|
|
|
POSSIBLE CAUSE
|
• Mis-installation of wheel unit
• Wheel unit malfunction
• Instrument cluster malfunction
|
|
|
SYSTEM WIRING DIAGRAM
|
Not applicable
|
|
Diagnostic Procedure
|
Step |
Inspection |
Action |
|
|---|---|---|---|
|
1
|
VERIFY WHEEL UNIT IS INSTALLED TO EACH WHEEL
• Visually inspect the wheel unit.
• Are all four wheels installed with a wheel unit?
|
Yes
|
Go to the next step.
|
|
No
|
Install and register the wheel unit, then go to Step3.
(See WHEEL UNIT ID REGISTRATION.)
|
||
|
2
|
IDENTIFY MALFUNCTIONING WHEEL UNIT
• Identify the malfunctioning wheel unit.
• Is there any malfunctioning wheel unit?
|
Yes
|
Replace and register the malfunctioning wheel unit, then go to the next step.
(See WHEEL UNIT ID REGISTRATION.)
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY INSTRUMENT CLUSTER DTC
• Using the M-MDS, clear the DTC from the instrument cluster.
• Drive the vehicle at speed of 25 km/h {16 mph} or more for 8 min or more.
• Using the M-MDS, perform the instrument cluster DTC inspection.
• Is the same Pending DTC present?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the instrument cluster.
Go to the next step.
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY NO DTC IS PRESENT
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||