DTC U3000:42 [INSTRUMENT CLUSTER (TPMS)]

id020210811900

DTC	U3000:42	Instrument cluster internal malfunction
DETECTION CONDITION		•  Instrument cluster internal malfunction is detected.
FAIL-SAFE FUNCTION		•  Refer to “Fail-safe function table”. (See DTC TABLE [INSTRUMENT CLUSTER (TPMS)].)
POSSIBLE CAUSE		•  Instrument cluster malfunction
SYSTEM WIRING DIAGRAM		Not applicable

Diagnostic Procedure

Step	Inspection		Action
1	VERIFY INSTRUMENT CLUSTER DTC •  Using the M-MDS, clear the DTC from the instrument cluster. (See CLEARING DTC [INSTRUMENT CLUSTER (TPMS)].) •  Using the M-MDS, perform the instrument cluster DTC inspection. (See DTC INSPECTION [INSTRUMENT CLUSTER (TPMS)].) •  Is the same Pending DTC present?	Yes	Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
		No	Go to the next step.
2	VERIFY NO DTC IS PRESENT •  Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER (TPMS)].)
		No	DTC troubleshooting completed.