DTC C0001:01/C0003:01/C0010:01/C0011:01/C0014:01/C0015:01/C0018:01/C0019:01/C001C:01/C001D:01 [DYNAMIC STABILITY CONTROL (DSC)]
id0402b2880600
|
DTC |
C0001:01 |
DSC HU/CM internal malfunction (Linear control solenoid valve system) |
|
|---|---|---|---|
|
C0003:01 |
DSC HU/CM internal malfunction (Linear control solenoid valve system) |
||
|
C0010:01 |
DSC HU/CM internal malfunction (LF inlet solenoid valve system) |
||
|
C0011:01 |
DSC HU/CM internal malfunction (LF outlet solenoid valve system) |
||
|
C0014:01 |
DSC HU/CM internal malfunction (RF inlet solenoid valve system) |
||
|
C0015:01 |
DSC HU/CM internal malfunction (RF outlet solenoid valve system) |
||
|
C0018:01 |
DSC HU/CM internal malfunction (LR inlet solenoid valve system) |
||
|
C0019:01 |
DSC HU/CM internal malfunction (LR outlet solenoid valve system) |
||
|
C001C:01 |
DSC HU/CM internal malfunction (RR inlet solenoid valve system) |
||
|
C001D:01 |
DSC HU/CM internal malfunction (RR outlet solenoid valve system) |
||
|
DETECTION CONDITION
|
• Malfunction detected in the DSC HU/CM solenoid valve or internal circuit by the DSC HU/CM on-board diagnostic function
|
||
|
FAIL-SAFE FUNCTION
|
• Refer to “Fail-safe Function Malfunction Contents”. (See DTC TABLE [DYNAMIC STABILITY CONTROL (DSC)].)
|
||
|
POSSIBLE CAUSE
|
• Solenoid valve in DSC HU/CM malfunction
• Solenoid valve internal circuit in DSC HU/CM malfunction
• Poor connection at connectors (female terminal)
|
||
|
SYSTEM WIRING DIAGRAM
|
Not applicable
|
||
Diagnostic Procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY SOLENOID VALVE OPERATION
• Using the M-MDS, perform the simulation inspection for solenoid valve.
• Does the solenoid valve operate?
|
Yes
|
Go to the next step.
|
|
No
|
Replace the DSC HU/CM, then go to the next step.
|
||
|
2
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Using the M-MDS, clear the DTC from the DSC HU/CM.
• Start the engine and drive the vehicle at 6 km/h {4 mph} or more.
• Gradually slow down and stop vehicle.
• Using the M-MDS, perform the DSC HU/CM DTC inspection.
• Is the same Pending DTC present?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the DSC HU/CM.
Go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY NO DTC IS PRESENT
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||