CLUTCH DISC INSPECTION [D66M-R, D66MX-R]

id0510mf157500

Caution

•  The clutch cover equipped on the D66M(X)-R cannot be removed once and then reinstalled. For this reason, do not remove the clutch cover when performing the inspection.

1.  Remove the manual transaxle. (See MANUAL TRANSAXLE REMOVAL/INSTALLATION [D66M-R].) (See MANUAL TRANSAXLE REMOVAL/INSTALLATION [D66MX-R].)

2.  Adjust the thickness of the thickness gauge to 2.5 mm {0.098 in}.

3.  Insert the thickness gauge from the notch of the dual-mass flywheel and verify that the facing on the clutch cover side is thicker than the thickness gauge.

ac5wzw00011776

•  If the facing on the clutch cover side is thinner than the thickness gauge, replace the clutch disc and clutch cover as a single unit. (See CLUTCH UNIT REMOVAL/INSTALLATION [D66M-R, D66MX-R].)