AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [FW6A-EL]

id0517h1118600

Warning
•  Do not perform the servicing while the ATF is hot. Otherwise, it could cause severe burns or serious injury.

1.  Remove the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)

2.  Disconnect the wiring harness from the front crossmember. (With i-ELOOP)

am6zzw00008428

3.  Remove the dipstick securing bolt.

ac5uuw00001571

4.  Remove the dipstick.

5.  Remove the drain plug and washer, and drain the ATF.

ac5uuw00006505

6.  Install a new washer and drain plug.

Tightening torque
30—41 N·m {3.1—4.1 kgf·m, 23—30 ft·lbf}

7.  Add ATF from the dipstick installation hole.

Note
•  The ATF color is blue.
•  Only use ATF FZ for the FW6A-EL.

ATF type

Resupply amount (Reference)
ATF FZ
ATF is drained from drain plug: 3.3 L {3.5 US qt, 2.9 Imp qt}

8.  Adjust the ATF level. (See AUTOMATIC TRANSAXLE FLUID (ATF) ADJUSTMENT [FW6A-EL].)

9.  Insert the dipstick and install the securing bolt.

ac5uuw00001571

Tightening torque
8—11 N·m {82—112 kgf·cm, 71—97 in·lbf}

10.  Connect the wiring harness to the front crossmember. (With i-ELOOP)

am6zzw00016466

11.  Install the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)