DTC C0061:29/C0062:29/C0063:29/P0666:29 [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)]

id0802g8890200

Note

• The SRS air bag system can be identified by whether or not the seat track position sensor is present.

― Standard deployment control system: Without seat track position sensor

― Two-step deployment control system: With seat track position sensor

System malfunction location

•  C0061:29: Low-G sensor (lateral-G) in SAS control module (internal circuit disabled)

•  C0062:29: Low-G sensor (forward-G) in SAS control module (internal circuit disabled)

•  C0063:29: Yaw rate sensor in SAS control module (internal circuit disabled)

•  P0666:29: Temperature sensor in SAS control module (internal circuit disabled)

Detection condition

Warning

•  Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.

•  SAS control module internal sensor has a malfunction

Fail-safe

Not applicable

Possible cause

•  SAS control module malfunction

System wiring diagram

Not applicable

System malfunction location	• C0061:29: Low-G sensor (lateral-G) in SAS control module (internal circuit disabled) • C0062:29: Low-G sensor (forward-G) in SAS control module (internal circuit disabled) • C0063:29: Yaw rate sensor in SAS control module (internal circuit disabled) • P0666:29: Temperature sensor in SAS control module (internal circuit disabled)
Detection condition	Warning • Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure. • SAS control module internal sensor has a malfunction
Fail-safe	Not applicable
Possible cause	• SAS control module malfunction
System wiring diagram	Not applicable

Diagnostic Procedure

Step

Inspection

Action

1

PERFORM SAS CONTROL MODULE DTC INSPECTION

•  Clear the DTC for the SAS control module using the M-MDS. (See CLEARING DTC [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)].)

•  Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC INSPECTION [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)].)

•  Are the same Pending DTCs present?

Yes

Replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM].)

No

DTC troubleshooting completed.

Step	Inspection		Action
1	PERFORM SAS CONTROL MODULE DTC INSPECTION • Clear the DTC for the SAS control module using the M-MDS. (See CLEARING DTC [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)].) • Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC INSPECTION [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)].) • Are the same Pending DTCs present?	Yes	Replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM].)
1		No	DTC troubleshooting completed.