DTC B00D3:01 [SAS CONTROL MODULE (ACTIVE BONNET)]


id0802h4006300

System malfunction location

•  Active bonnet warning light malfunction
Detection condition
Warning
•  Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.
•  Active bonnet warning light malfunction detected
Fail-safe function
Not applicable
Possible cause
•  Active bonnet warning light malfunction
System wiring diagram
Not applicable


Diagnostic Procedure

STEP

INSPECTION

ACTION

1
PERFORM INSTRUMENT CLUSTER DTC INSPECTION
•  Perform the instrument cluster DTC inspection using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER].)
•  Are any DTCs present?
Yes
Perform the applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER].)
No
Go to the next step.
2
INSPECT INSTRUMENT CLUSTER
•  Perform the active command mode inspection for the instrument cluster using the M-MDS.
•  Does the active bonnet warning light illuminate?
Yes
Go to the next step.
No
Replace the instrument cluster.
Then go to the next step.
3
PERFORM SAS CONTROL MODULE DTC INSPECTION
•  Clear the DTC for the SAS control module using the M-MDS.
•  Perform the DTC inspection for the SAS control module using the M-MDS.
•  Is the same Pending DTC present?
Yes
Replace the SAS control module.
No
DTC troubleshooting completed.