POWER STEERING PRESSURE (PSP) SWITCH INSPECTION [MZR-CD (RF Turbo)]

Note

• Perform the following inspection only when directed.

Continuity Inspection

1. Inspect the following if the power steering is inoperative:

• Power steering fluid level

• Power steering fluid leakage

• Power steering fluid pressure

2. Disconnect the PSP switch connector.

3. Start the engine.

4. Inspect for continuity between PSP switch terminal A and body GND using an ohmmeter.

• If the PSP switch is okay, perform the "Circuit Open/Short Inspection".

• If not as specified, replace the PSP switch. (See POWER STEERING OIL PUMP DISASSEMBLY/ASSEMBLY [MZR-CD (RF Turbo)].)

Specification

Circuit Open/Short Inspection

1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION [MZR-CD (RF Turbo)].)

2. Inspect the following harnesses for open or short circuit. (Continuity check)

Open circuit

• PSP switch terminal A and PCM terminal 111

Short circuit

• PSP switch terminal A and power supply

• PSP switch terminal A and body ground