1. On level ground, jack up the vehicle and support it evenly on safety stands.
2. Drain the oil from the transfer. (See TRANSFER OIL REPLACEMENT [A26MX-R].)
3. Remove the joint shaft. (See JOINT SHAFT REMOVAL/INSTALLATION [L3 Turbo])
4. Remove the oil seals using a screwdriver.
5. Using the SST and a hammer, tap each new oil seal.
6. Coat the lip of each oil seal with transfer oil.
7. Install the joint shaft. (See JOINT SHAFT REMOVAL/INSTALLATION [L3 Turbo])
8. Add the specified amount and type of oil. (See TRANSFER OIL REPLACEMENT [A26MX-R].)