|
STEP
|
INSPECTION
|
ACTION
|
|
1
|
VERIFY WHETHER MALFUNCTION IS IN WARNING LIGHTS AND INDICATOR LIGHTS' COMMON POWER SUPPLY, OR IN OTHER WARNING LIGHTS AND INDICATOR LIGHTS
• Do other warning and indicator lights illuminate when IG switch is turned ON?
|
Yes
|
Go to step 4.
|
|
No
|
Go to next step.
|
|
2
|
INSPECT INSTRUMENT CLUSTER POWER SUPPLY FUSE
• Is instrument cluster ignition power supply fuse normal?
|
Yes
|
Go to next step.
|
|
No
|
Check for a short to ground on blown fuse's circuit.
Repair or replace as necessary.
Install appropriate amperage fuse.
|
|
*3
|
VERIFY WHETHER MALFUNCTION IS IN WIRING HARNESS (BETWEEN INSTRUMENT CLUSTER POWER SUPPLY AND INSTRUMENT CLUSTER FOR CONTINUITY) OR INSTRUMENT CLUSTER
• Turn ignition switch ON.
• Measure voltage at instrument cluster connector (24-pin) terminal 2V.
• Is voltage approx. 12 V?
|
Yes
|
Replace instrument cluster (open circuit in instrument cluster).
|
|
No
|
Inspect for open circuit between instrument cluster and ground.
Repair or replace as necessary.
|
|
4
|
CONFIRM DTC U1900 USING WDS OR EQUIVALENT
• Retrieve DTC from PCM, ABS (ABS/TCS), and instrument cluster.
• Is DTC U1900 retrieved?
|
Yes
|
Go to next step.
|
|
No
|
Inspect instrument cluster. If OK, then go to step 6.
|
|
5
|
CONFIRM THE FOLLOWING PIDs USING WDS OR EQUIVALENT
• ABS_MSG
• PCM_MSG
• Is "not present'' massage displayed on WDS or equivalent?
|
Yes
|
Replace instrument cluster (open circuit in instrument cluster).
|
|
No
|
Network communication, for related system is malfunction.
Repair or replace as necessary.
|
|
6
|
CONFIRM DTC B2477 FOR INSTRUMENT CLUSTER USING WDS OR EQUIVALENT
• Retrieve DTC from PCM, ABS, and instrument cluster.
• Is DTC B2477 retrieved?
|
Yes
|
Re-configure the instrument cluster.
|
|
No
|
Replace ABS HU/CM.
|
|
|