PID/DATA MONITOR AND RECORD [WATER HEATER SYSTEM]


id070200801928

PID Monitoring Item Table

PID Name

(Definition)

Unit/Condition

Condition/Specification

(Reference)

Action

Water Heater Unit terminal

CCNTFFH
(Number of continuous codes)
-
• DTC is detected: 1-255
• DTC is not detected: 0
Perform inspection using appropriate DTC.
-
ECT
(Engine coolant temperature)
°C
°F
• ECT 20 °C {68 °F}: 20 °C {68 °F}
• ECT 60 °C {140 °F}: 60 °C {140 °F}
-
-
VPWR_FFH
(Module supply voltage)
V
• Ignition switch ON: B+
Inspect water heater unit power supply terminal.
A
VPWR_LMT
(Low voltage threshold)
V
• Ignition switch ON: approx. 9.5 V
Inspect water heater unit power supply terminal.
A
FAN
(Fan control)
%
• Blower fan is not operating: 0 %
• Blower fan is operating: 0-100 %
-
-
GPD
(Glow plug duty cycle)
%
• Water heater unit is not operating: 0 %
• Water heater unit is operating: 0-100 %
-
-
BLOWRMTR
(Blower motor)
On/Off
• Blower fan is not operating: Off
• Blower fan is operating: On
-
-
FP
(Fuel pump)
On/Off
• Water heater unit is not operating: Off
• Water heater unit is operating: On
-
-
WATER_PMP
(Water pump)
On/Off
• Water heater unit is not operating: Off
• Water heater unit is operating: On
-
-
GLOW PLUG
(Glow plugs)
On/Off
• Water heater unit is not operating: Off
• Water heater unit is operating: On
-
-
COMB_FAN
(Combustion air fan)
On/Off
• Water heater unit is not operating: Off
• Water heater unit is operating: On
-
-
LOCKPUT
(Heater lockout)
Lock/Unlock
• Water heater unit is not operating: Lock
• Water heater unit is operating: Unlock
-
-
FS
(Flame sensor)
On/Off
• Water heater unit is not operating: Off
• Water heater unit is operating: On
-
-
HEATER
(Heater status)
Inactive/Active
• Water heater unit is not operating: Inactive
• Water heater unit is operating: Active
-
-
HEATER_SW
(Heater activation switch)
Inactive/Active
• Water heater unit is not operating: Inactive
• Water heater unit is operating: Active
-
-

Simulation Test Item Table

Item

Definition

Operation

Water Heater Unit terminal

CLR_LOCKOUT
Heater lockout mode clearing command
On/-
-
FUEL_PRIME
Fuel pump priming command
(The fuel pump is activated for 5 s.)
On/-
-