A/C UNIT REMOVAL/INSTALLATION [MZR-CD (RF Turbo)]

id0711008002d3

1. Disconnect the negative battery cable.

2. Discharge the refrigerant from the system. (See REFRIGERANT RECOVERY.) (See REFRIGERANT CHARGING.)

3. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT [MZR-CD (RF Turbo)].)

4. Remove the dashboard. (See DASHBOARD REMOVAL/INSTALLATION.)

5. Remove the theft-deterrent control module. (See THEFT-DETERRENT SIREN REMOVAL/INSTALLATION.)

Caution

• If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and abnormal noise will occur. Always immediately plug open fittings after removing any refrigeration cycle parts to keep moisture or foreign material out of the cycle.

6. Remove in the order indicated in the table. Do not allow compressor oil to spill.


1	Heater hose
2	Cooler pipe No.4 (L.H.D.) or cooler pipe No.5 (R.H.D.) (See Refrigerant Lines Removal Note.) (See Refrigerant Lines Installation Note.)
3	Cooler pipe No.3 (See Refrigerant Lines Removal Note.) (See Refrigerant Lines Installation Note.)
4	A/C unit

7. Install in the reverse order of removal.

8. Perform the refrigerant system performance test.