PID/DATA MONITOR TABLE [HEADLIGHT AUTO LEVELING SYSTEM]


id0902i7862100

LHID

PID Name

(Definition)

Unit/Condition

Condition/Specification

Auto Leveling Control Module (Main) terminal

CCNT
(Number of continuous codes)
-
• DTC is detected: 1-255
• DTC is not detected: 0
-
ONDEMDTC
(Number of on-demand codes)
-
• DTC is detected: 1-255
• DTC is not detected: 0
-
LHIDIGNV
(Auto leveling control module (main) input voltage)
VOLTAGE
Ignition switch at ON:

B+

L
F_CAL
(Signal input from front auto leveling sensor at time of headlight zeroset (stored in memory))
VOLTAGE
Ignition switch at ON:

0.5-4.5 V

-
F_LEVEL
(Current input signal sent from front auto leveling sensor)
VOLTAGE
Ignition switch at ON:

0.5-4.5 V

G,H,K
R_CAL
(Signal input from rear auto leveling sensor at time of headlight zeroset (stored in memory))
VOLTAGE
Ignition switch at ON:

0.5-4.5 V

-
R_LEVEL
(Current input signal sent from rear auto leveling sensor)
VOLTAGE
Ignition switch at ON:

0.5-4.5 V

F,G,K
L_REFLECTOR
(Headlight leveling actuator angle control output signal sent to auto leveling control module (sub))
ANGLE
Ignition switch at ON:

-5-4

I
STP_MTR_L
(Headlight leveling actuator (LH) current position)
STEP
Ignition switch at ON:

12-520

Q,R,S,T
LHID_VSS
(Vehicle speed input signal from ABS/TCS HU/CM)
KPH
• Vehicle is stopped: 0 KPH {0 MPH}
• Vehicle is driving: Indicates vehicle speed
P
PART#SUF*
(Part number identification should be displayed)
-
-
-
SERIAL#1*
(Auto leveling control module serial number part 1 should be displayed)
-
-
-
SERIAL#2*
(Auto leveling control module serial number part 2 should be displayed)
-
-
-
SOFTVER*
(Software version number should be displayed)
-
-
-
L_VOLT_L
(Discharge headlight control (LH) input voltage)
VOLTAGE
Headlight switch at ON:

B+

D
GDL_P_L
(Output power to discharge headlight bulb (LH))
WATT
Headlight switch at ON:

35-65 W

-
GDL_V_L
(Output voltage to discharge headlight bulb (LH))
VOLTAGE
Headlight switch at ON:

68-112 V

-

* :
Unnecessary for diagnosis

RHID

PID Name

(Definition)

Unit/Condition

Condition/Specification

Auto Leveling Control Module (Sub) terminal

CCNT
(Number of continuous codes)
-
• DTC is detected: 1-255
• DTC is not detected: 0
-
ONDEMDTC
(Number of on-demand codes)
-
• DTC is detected: 1-255
• DTC is not detected: 0
-
RHIDIGNV
(Auto leveling control module (sub) input voltage)
VOLTAGE
Ignition switch at ON:

B+

L
R_REFLECTOR
(Headlight leveling actuator angle control input signal sent from auto leveling control module (main))
ANGLE
Ignition switch at ON:

-5-4°

P
STP_MTR_R
(Headlight leveling actuator (RH) current position)
STEP
Headlight switch at ON:

12-520

Q,R,S,T
PART#SUF*
(Part number identification should be displayed)
-
-
-
SERIAL#1*
(Auto leveling control module serial number part 1 should be displayed)
-
-
-
SERIAL#2*
(Auto leveling control module serial number part 2 should be displayed)
-
-
-
SOFTVER*
(Software version number should be displayed)
-
-
-
L_VOLT_R
(Discharge headlight control module (RH) input voltage)
VOLTAGE
Headlight switch at ON:

B+

D
GDL_P_R
(Output power to discharge headlight bulb (RH))
WATT
Headlight switch at ON:

35-65 W

-
GDL_V_R
(Output voltage to discharge headlight bulb (RH))
VOLTAGE
Headlight switch at ON:

68-112 V

-

* :
Unnecessary for diagnosis