AUTO LEVELING CONTROL MODULE CONSTRUCTION/OPERATION
id091800103800
• The auto leveling control modules (main and sub) are installed within the discharge control modules, located under the front combination lights.
• The auto leveling control module (main) verifies changes in vehicle speed and attitude based on signal inputted from the ABS (DSC) HU/CM, and front and rear auto leveling sensors. The unit then calculates the optimal direction for the optical axis and sends signal to the auto leveling control module (sub).
• Based on the calculation of the optical axis adjustment amount, the auto leveling control module controls the headlight leveling actuator.
-
Caution
-
• After performing the following service items, configuration and zeroset must be performed using the WDS or equivalent.
×:Applied
-:Not applied
|
|
Service Item
|
Auto Leveling control module Configuration
|
Headlight Zeroset *1
|
Headlight Aiming *1
|
|
1
|
Auto leveling control module (main or sub) replaced with new part.
|
×
|
×
|
×
|
|
2
|
Front combination light removal/installation
|
-
|
-
|
×
|
|
3
|
Front auto leveling sensor or rear auto leveling sensor replaced with new part, or harness or connector replaced with new part.
|
-
|
×
|
×
|
|
4
|
Front auto leveling sensor connector or rear auto leveling sensor connector removal.
|
-
|
×
|
×
|
|
5
|
Front auto leveling sensor or rear auto leveling sensor removal/installation.
|
-
|
×
|
×
|
-
*1 :
Execute headlight aiming for both headlights and together with headlight zeroset (which is performed by auto leveling control module (main))